› ›

ebross

About

Username
ebross
Joined
Visits
18
Last Active
Roles
Member

Comments

  • I switched to the PID controller and put in the values: Kp: 38.74 Ki: 7.52Kd: 49.91 The hot end is working and holding temp at desired setting. I could not get the Deadtime controller to work properly. no matter what I set it to it was swinging wide…
    in Extruder Temp Sensor Comment by ebross May 2016
  • I ran M303 P0 S180, and this is what I got. 10:51:11.924 : Info:PID Autotune start10:53:02.061 : bias: 109 d: 109 min: 178.91 max: 181.5710:53:12.522 : bias: 100 d: 100 min: 179.00 max: 181.3510:53:22.613 : bias: 104 d: 104 min: 179.00 max: 181.0110…
    in Extruder Temp Sensor Comment by ebross May 2016