› ›

genn

About

Username
genn
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Thank you for the prompt ansewer Ok, I would imagine that will be fixed in future releases, right? However, please note,  my table shows that even at nominal speed settings (100 ) the ETA is wrong
    in ETE Estmiation improvement Comment by genn April 2022
  • Hi, I just upgraded from reperier host 2.1.6 to 2.2.4 My printer is almost finishing to print a vase (may be 10-15 minutes to end) and there is some problem with ETA:This is the ETA table I get, based on print speed setting SPEED     ETA  100       …
    in ETE Estmiation improvement Comment by genn April 2022
  • Repetier, I just forgot to tell you I am using 1.0.6 and still suffer of the problem detailed by robnee. I went down to mouse wheel set to 1 line/click, with very little progress. This is very strange ,as the mouse reacts normally in all other progr…
    in Mouse wheel zooming broken in version 1.05 Windows Comment by genn October 2014
  • No need to see the video, robnee has been very clear to detail the problem. I fully agreed with him. Zooming is now almot impossible, preventing a detailed check of the slices. Repetier, Is there any sort of patch we can apply, prior the the next…
    in Mouse wheel zooming broken in version 1.05 Windows Comment by genn October 2014