› ›

FelixP

About

Username
FelixP
Joined
Visits
41
Last Active
Roles
Member

Comments

  • ok, but my settings for the endstops are no longer valid, by quite a lot. the carriage on tower b will now drop a significant amount when homing, and the offsets put in the firmware for the endstops are no longer valid. Is this supposed to be happen…
    in How do I use Delta Correction? Comment by FelixP May 2015
  • I applied the corrections, and now all the endstop positions are out of whack. is this supposed to happen?
    in How do I use Delta Correction? Comment by FelixP May 2015
  • ACK! I actually put them in the wrong spots, give me a minute to see what happens when I swap them around.
    in How do I use Delta Correction? Comment by FelixP May 2015
  • I mistyped that. I meant to say side B is 120.88 mm long and side C is 120.08 mm long.
    in How do I use Delta Correction? Comment by FelixP May 2015
  • Okay. Here's what I got: when side A is 120 mm long, side B is 120.08 mm long and side C is 120.88 mm long, I calculated: ( 120.88 / 120 ) * 392.35 = 395.227395.227 - 392.35 = 2.877 (392.35 is my diagonal rod length) So I put 2.877 into Corr. diagon…
    in How do I use Delta Correction? Comment by FelixP May 2015
  • I'm not sure if I've read your suggestion correctly. Currently, the angles are very close to 120 degrees, but the lengths of the legs on the object are not.  The length of the leg closest to Tower B and the leg colinear with that leg measure the len…
    in How do I use Delta Correction? Comment by FelixP May 2015
  • Ok, so for example, with the 120.95, I put -.95 into the tower B radius correction? is that right?
    in How do I use Delta Correction? Comment by FelixP April 2015
  • Unfortunately my googlefu is weak. Where are these schematics for wiring a potentiometer to each FSR?
    in free EEPROM memory locations Comment by FelixP November 2014
  • You can close this topic, I read the instructions on how to manually calibrate the radius wrong. Instead of measuring the center, i was supposed to measure the points near the edge of the bed
    in Calibration problems Comment by FelixP November 2014