› ›

ME1

About

Username
ME1
Joined
Visits
7
Last Active
Roles
Member

Comments

  • Repetier said:[...] What board/serial driver does it use in case I can replay it? I am using an Arduino Due as board with firmware Repetier_0.92.4, which was specifically made by my printer maker (it is a Construction Zone CZ1 Vers…
    in Printer will reset, but not connect Comment by ME1 June 2019
  • Repetier said: Some serial drivers do not support non ansi baud rates as well, so setting the multiplier fails or is not exact. I have a similar problem with the new repetier host 2.1.6 on Ubuntu 18.04. The printer is resetted when con…
    in Printer will reset, but not connect Comment by ME1 June 2019
  • Ah yes and the #define X_HOME_DIR -1 #define Y_HOME_DIR -1 #define Z_HOME_DIR 1 was also wrong. This was also necessary to make it work: #define X_HOME_DIR 1 #define Y_HOME_DIR 1 #define Z_HOME_DIR 1
    in Homing problem with delta printer Comment by ME1 July 2016
  • Deltas home all to max and at the beginning all motors move the same time until endstop is triggeren which stops the according axis. Current firmware release even has a test if endstop triggering/untriggering worked as expected. You would see this i…
    in Homing problem with delta printer Comment by ME1 July 2016