Exinferis
About
- Username
- Exinferis
- Joined
- Visits
- 31
- Last Active
- Roles
- Member
Comments
-
Hmm, I think I set it to 2us because the repetier fw wizard said so because I got due(udoo quad) but doesn't matter really. I'll just let it be very slow til I change it to belt powered ☺️
-
The data sheet on my driver doesn't say anything about timer, but max pulse frequency is 100khz. They are made for nema23 so power isn't the problem. Maybe I should try increasing the pulse delay. I think I have it at 2 us at the moment
-
I think its during start it stalls. The leadscrew on my y-axis is quite large. I think it's 12mm diameter. And 5mm per revolution. I'm guessing that's quite high thread mass The steps per mm is 320, so that can't be the problem, my x axis is mu…
-
sorry, i meant the z axis output on the radds. Not the external driver
-
Its actually the controller connected to the native z axis on radds thats acting up... I tried swapping them around, and the problem followed the controller..
-
Well i feel like a propper idiot now.... In all my haste i didnt realize that the 3 pin connector was 180 degrees wrong on those that made it reboot :
-
Yeah, well I had quite the brainfart when I wrote the part about the pinout. Those are easy to find I will have to try with correct pinout and see if my driver work with 3.3v it it does it will surely make this easier A level shifter will do the…
-
I can add that i have a radds 1.5. And im beginning to wonder if this is actually possible, the pins on the radds are called 11,12,21,22 and im not sure if that is the EN,DIR,ST and GND i need
-
Thanks for answering. I didnt realize you could only install the server part. That is why in my noobishness i bought the udoo quad over the arduino due, cause i wanted the option of controlling the printer over my home network. even if i cant get t…