› ›

gwolfsystems

About

Username
gwolfsystems
Joined
Visits
20
Last Active
Roles
Member

Comments

  • Ok ok. I will try changing the design of the fanduct thank you very much!!
    in Problem to start printing Comment by gwolfsystems July 2016
  • I was watching the printer and I found that the layer fan start at first layer, even when I turn off in the first layers in the slicer.This is why the hotend gets cold and the protection and repetier stops printing. Is there any way to turn off and …
    in Problem to start printing Comment by gwolfsystems July 2016
  • I've tried changing the firmware to repetier firmware. Now it heats up, start printing but, after a couple of layers, the heatbed and hotend turns off, the extruder stops printing but it keeps doing the movements in x, y, z. What can it be?
    in Problem to start printing Comment by gwolfsystems July 2016