› ›

AleXileD

About

Username
AleXileD
Joined
Visits
10
Last Active
Roles
Member

Comments

  • having the same problem Ramps 1.4Reprap Full graphic smartcontrollerRepetier firmware 0.92 (latest) uploaded with Arduino IDE 1.6.7and when in insert an SD card formatted in FAT32 nothing happens and SD in controller is empty even though i copied .g…
    in Problems to get SD Card work. Comment by AleXileD March 2016
  • Can confirm retraction works again when uploading the newest firmware with the Arduino 1.6.7 IDE! In the manual control I still can only press extrude once .. then I have to press retract before I can extrude again. does anyone know why? Thanks!!! 
    in Retraction / reverse extrusion not working Comment by AleXileD March 2016
  • Still having this problem on my ramps 1.4 board with FW 9.28.. uploaded with arduino IDE 1.6.5.. will be trying with IDE 1.6.7 tommorow
    in Retraction / reverse extrusion not working Comment by AleXileD March 2016
  • I am having the same issue with Slic3r embedded in Repetier.. I set retraction 4mm in slicer but there is no retraction gcode when I take a look in the G-Code editor. Do I need to enable autoretract conversion? because I also see no G10/11 commands …
    in Slicer Not Retracting Comment by AleXileD March 2016