electricalENG
About
- Username
- electricalENG
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
Found the problem! You were right, connector was plugged into the wrong pins on the board. Thanks for the help.
-
I've tried changing Xmin inverting to true and pullup Xmin (not sure what this does) to true but these don't have any effect.
-
The endstop signal measures 5V when not triggered and 0V when triggered. I measured from the endstop itself as well as where the cable plugs into the board. It seemed to work fine for years then all of a sudden stop working a few weeks ago. The ends…
-
When I sent M119 I got the following code: endstops hit: x_min:H z_min:H This is with the x endstops not triggered. When I trigger the endstops and check again I get the same message. Seems like the endstops being triggered is not getting picked up…