Nate3Der523
About
- Username
- Nate3Der523
- Joined
- Visits
- 40
- Last Active
- Roles
- Member
Comments
-
Ahh, well that explains why it works when I connect USB then. Now just need to figure out if I can get it to reset when I apply power, maybe if I have the astroprint gateway connected to the programming port this will work out will let you know when…
-
Okay, yep, resetting the board allows it to boot up without USB and just power. However, I have to do it everrytime. Guess that's what I get for buying a cheap brand of due. Wonder if I can add a command on bootup that resets the board on startup.
-
So I have Windows 10, can confirm that when I updated to Version 2.0, that the eeprom was greyed out. m115 returned eeprom : 1, so it was enabled, however still not able to access it. What I did is went to the configuration tool online, load my old …
-
Thanks that makes more sense now! I am suspicious of a problem with my Z-Prove, it is an inductive proximity sensor, which uses magnetic field. Buildtak Flexplate System which I have uses magnets to hold the bed down. Do you think this will mess up …
-
I will try and mess with that, any answer to the equation? What is Znew and Zold reperesenting?
-
I am just having a real hard time trying to get this autlevling feature to work with repetier. I've tried reading many sources, and nothing seems to be straight forward. I am totally confused about something, because I have calibrated the printer by…
-
Hmm I will have to give that a shot, thanks for the information guys.
-
lol, that didn't work, made it way off, I did find however just adding resistors in series that it matches within 2-5 C between 170 and 235 when I have a 220 ohm resistor in series with the thermistor. That's much better than 100 C off, but still, w…
-
If I wanted to just reduce that using ohms law, I am coming out to a around 40K resistor in parralell with th eboard to make the total resistance 4.7K, does that seems right? 4.7k = 1/(1/5.36K+1/R) then solve for R?
-
Right now am waiting for the extruder to reach room temperature so I can measure the resistor in the extruder too. I did measure the pins in the board, I got 5.36K, so with that knowledge what do I change now to make to correct?
-
Will do, its a ramps 1.4 board if that helps.
-
Nope, wait, that is the type I use .. and I am still way off so it has to be something else in the electronics maybe?
-
Thanks! I will give that a shot and see!
-
Thanks that helps a lot, little things like that bug me sometimes!
-
Thanks for your help! I'll check that out!
-
I guess I should say that I don't want distortion correcting for that, because it only goes for the first few layers.
-
Thanks was driving me nuts! Works like it does in the video with G33. Problem I am having now though is it seems I haven't quite calibrated my gaps correctly, namely the gaps between x-y, y-z, an z-x. they are 0.7mm off, time to get a little more ni…
-
What I ahve done so far is added this to the configuration.h int computeChecksum(){ return 0;} makes it happy but bad way to fix it I think. Especially because I don't know what it does:)