ldanut
About
- Username
- ldanut
- Joined
- Visits
- 55
- Last Active
- Roles
- Member
Comments
-
No one can help with this?
-
I tested the SD card with version 0.91 and SD works perfect. As I understood there was some timing changed in 0.92 related to SD but not sure what are those. Can some one point me to where they are? Thanks.
-
It seems I have same issue as here: http://forum.repetier.com/discussion/727/printer-communication-problems
-
If I take out LCD cable for SD and use SD slot from RADDS I get same behavior.
-
I'm not sure how to debug this. When I insert the sd card it display "SD card inserted" and everything freeze for few seconds. After that in Repetier Host I get the error "SD init fail". If I go to see the content of SD card it show empty screen. I'…
-
You were right about menu navigation ... I took out and put back the cable from LCD and now it works. But regarding SD init fail the problem still persists. I read somewhere that the pin assigment for SD is wrong and need to change it?
-
Thanks for your help. Now I'm able to move axis smooth at 1/64 microstepping. Thermistors works, fans works, hot end works. But I have a strange issue with my LCD. When I click the wheel and go to menu I can navigate only between first two items. Al…
-
Also do you see any issue if i use raps128 drivers at 1/128 microstepping with 16tooth gt2 belts. This makes steps/mm for axis to be 800.
-
Thanks. Your config worked. Something in my config wasn't set correctly and also one motor had an imperfect wiring. The most notable differences in my config was: deltaSegmentsPerSecondPrint: 300, deltaSegmentsPerSecondTravel: 300, deltaSegmentsPer…
-
Here's my config file. I am still tweaking thing but it work quite well. https://www.dropbox.com/sh/lq7lcifbu1ytu5t/AAAUoGjSx0SXED9e2aQa7PPoa?dl=0 Radds 1.5***raps128***Delta ***Proximity probe***heatbed***one extruder*** Would you please provide …