bazis

About

Username
bazis
Joined
Visits
43
Last Active
Roles
Member

Comments

  • Mine works too. Thank you, Repetier.
  • Arduino 1.6.7, latest version from master (4.3.2016) - the same result, no manual extrusion.Arduino 1.6.5, repetier 0.92.6 - manual extrusion works.Arduino 1.6.5, repetier 0.92.7 - manual extrusion works. Arduino 1.6.5, latest version from master (4…
  • Printing work with DRIVE_SYSTEM 3,  except retraction. But this may be slicer settings issue, I will try print from Cura. From repetier host button commands extruder motor move in any direction only if I set DRIVE_SYSTEM 0.It works well with a speci…
  • I erased EEPROM dozens of times, try increase and decrease speed and acceleration in extruder. Try to invert motor direction and enable signal.Exported values from EEPROMExtr.1 steps per mm  Extr.1 max. feedrate  Extr.1 start feedrate  Extr.1 accele…