› ›

Zatsit

About

Username
Zatsit
Joined
Visits
6
Last Active
Roles
Member

Comments

  • 0.92.8 reloaded from the configurator, then compiled with a freshly reinstalled 1.6.7 Arduino IDE : everything works fine ! Thanks, Repetier !
    in Extruder motor issue on Delta Comment by Zatsit March 2016
  • Hi, Same symptoms here with a basic RAMPS delta printer under 0.92.8 : Extruder does not move, except while printing.  Since my hardware is over-tested with previous RFW versions installed on the same RAMPS combo, I started going crazy. I am relieve…
    in Extruder motor issue on Delta Comment by Zatsit March 2016