Hecot
About
- Username
- Hecot
- Joined
- Visits
- 8
- Last Active
- Roles
- Member
Comments
-
Could be caused by a loose contact on the heating element ... !? I had this bug on my printer randomly stop heating in the middle of the print. After two weeks of search I found that this was caused by a loose contact on the extruder heating element…
-
I'm using an microSD extension cable with the DaVinci 1.0! I'm not sure if the board got a pin to detect the SD-card when inserted. All I know is that I need to powercycle the printer to get the card recognised, so I assume there is no such pin!??I'…
-
Hi there! I like to have the convenience of a mount/unmount command in sd card menu as well, but using a XYZ Davinci 1.0 - with 0.92 what to change for this printer? THANKS!
-
Have you checked that autolevel is switched on (set to 1) in the firmware!?