Tazzat

Comments

• But Connection to printer over USB is stil broken..Where do i find the new boot loader? avrdude: stk500_getsync(): not in sync: resp=0x00

  in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Tazzat March 2016
• Thanks osnwtPut in a SD card and the printer boots 0.92.8 just fine now..

  in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Tazzat March 2016
• Did not get the time to test.. try this weekend..

  in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Tazzat March 2016
• Repetier-host is connected (green) using same baud rate.. Can try no display later today..

  in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Tazzat March 2016
• Just innstaled repetier-host ,did not change anything.. The OK is me pressingen OK button in repetier-host.

  in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Tazzat March 2016
• If youg ot the time you can have a look over teamviewer..

  in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Tazzat February 2016
• Now reuploading 0.92.5 i get this Binary sketch size: 119 602 bytes (of a 131 072 byte maximum)avrdude: stk500_getsync(): not in sync: resp=0x00 Flash bootloader and upload  0.92.5 again work..

  in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Tazzat February 2016
• Uploaded 0.92.8 11:33:59.413 : Communication timeout - reset send buffer block11:33:59.413 : N11 M105*2311:34:02.284 : N12 M105*2011:34:05.349 : N13 M105*2111:34:08.408 : N14 M105*1811:34:11.478 : N15 M105*1911:34:14.546 : N16 M105*1611:34:17.613 : …

  in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Tazzat February 2016
• I set the pin to analog 1..?How can i do the logging? not an expert on tihs..

  in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Tazzat February 2016