Dr_Froggy_rD

Comments

• Dear all, I asked almost the same question at velleman.eu. As they use repetier host. Point: before being able to do anything from repetier, some lines in the firmware must be modified using arduino 1.0.6 (if I right understood) Without this, any …

  in k8200: z axis too _when trying to change eeprom configuration _even worth! Have a Guess?thx Comment by Dr_Froggy_rD March 2016
• The joke was only about the correct answer but not the correct one that one may expect. I have several others on the subject. At least you give me an answer. I appreciate that. thank again for your time and your answer. PS:I must say I do not kno…

  in k8200: z axis too _when trying to change eeprom configuration _even worth! Have a Guess?thx Comment by Dr_Froggy_rD February 2016
• Yes I understand. thanks again for your time. The reasons are clear now. However, you did not answered my question. (you know this joke whith two mathematicians in a boat - the two are lost - and cannot see any landscape to figure out where they are…

  in k8200: z axis too _when trying to change eeprom configuration _even worth! Have a Guess?thx Comment by Dr_Froggy_rD February 2016
• Dear Sir, Thx for your answer. So no way to compensate it by telling the software it must adjust the number of steps?  If I do 100 Measurements at different speed with the same calibration problem of the z axis (allways the same difference with "…

  in k8200: z axis too _when trying to change eeprom configuration _even worth! Have a Guess?thx Comment by Dr_Froggy_rD February 2016