Vince
About
- Username
- Vince
- Joined
- Visits
- 29
- Last Active
- Roles
- Member
Comments
-
It appears I can only extrude ninjaflex at 2mm/sec. (ABS seems ok at 8mm/sec at 255deg). Both on 0.5 nozzle. I guess I can use the new slicer volumemetric rate to make sure it dosent try to push out faster than this? So 1.75 filament at 2mm/ sec is …
-
Thanks, thats exactly what i needed. If the manufacturer claims it will extrude ninjaflex at xmm/sec and its not then I I know there is a problem without things like layer height etc clouding the issue.
-
OK so you do have a normal z min endstop. My new printer is the first one Iv fitted a z probe to and I thought you could get away without a z endstop .I think I read you can but it seems complex. I understand I can add 'probe start script' to lower …
-
Juulius Thanks for reply. I still dont know if you are using a separate Z endstop of some sort or just the z probe (wherever it may be connected). so a G32 does homing then probing. How is z homed without a dedicated z endstop. If I try a Z home it …
-
OK thats a shame as I got used to using the old type with all the comment lines. Still cant stop myself making instant changes especially as my internet connection here is intermittent. Even the JSON names are a bit different to the main text so a s…
-
I thought P was the servo number? Anyway I just got it working by using P0, presumably the first servo is P0? Does the Z PROBE START SCRIPT only get run when you start the print?
-
Indeed, i hope the switch position is irrelevant until after the z probe is extended (perhaps with a bit of delay) and hope it is ignored again BEFORE the z retract is triggered. Either way i hope its like this ... Ignore z switch (during all other…
-
Yes was thinking could level one axis at least without additional hardware. Am about to start my second DIY build and trying to decide 2 or 1 motors on z axis. Last one used one and belts and was very successful. I liked being able to grab the motor…