ShreddinPB

Comments

• Yes! That is it, I never bothered to set that since I think I am using the advanced bed probing, where it probes about 20 points

  in z correction probe NAN? Comment by ShreddinPB February 2016
• I see them in the firmware tho and they are all 0

  in z correction probe NAN? Comment by ShreddinPB February 2016
• I should say, I cant find it in the eeprom settings

  in z correction probe NAN? Comment by ShreddinPB February 2016
• I checked my settings, and found the one for bed coating which was 0.0, so I canged that to 0.001 just to make sure it has a value, but I can not find the bending correction setting in the firmware, whats it called?

  in z correction probe NAN? Comment by ShreddinPB February 2016