valerian
About
- Username
- valerian
- Joined
- Visits
- 33
- Last Active
- Roles
- Member
Comments
-
I use tmc2100 with cfg1 mode for more quiet, I tried all voltage between motors no move and drivers over heat (0.35v to 1.1v) and the verticals lines was every time there with no visible difference with the different voltage. I tried the same thing …
-
No, for be sure I removed the printer's belt, I started a dry print and I put 60cm of an other belt trough the gear of one of the two steppers, I held the two ends of the belt with a little force for accompany the move of the stepper end I've clearl…
-
Hi, I've got exactly de same problem. https://img11.hostingpics.net/pics/911265DSC00685.jpg Someone of you have found a solution since this last post? Except this problem my printer works very well, but all my print is ugly only because this. it ma…
-
OK ok, not very intuitive ^^ but thanks !
-
Thanks for your answer But I don't find what you talk about On slic3r http://www.zimagez.com/zimage/18c96b2e3fd138f2c13336059b5dc336c.php http://www.zimagez.com/zimage/27d7c12c92febdc4e7753f24573fef7d7.php On host http://www.zimagez.com/zimage/4…
-
I read that it was impossible to put tow different temperatures in repetier, is it possible to have such a big bug !? oO
-
The eeprom and the firmeware are the same, the z probe offset is 0 and I always do a homing before try z probing. My bed's radius is 110 mm. And, what's exactly that? #define BED_MOTOR_1_X 0 #define BED_MOTOR_1_Y 0 #define BED_MOTOR_2_X 200 #defin…
-
Thanks... it's better ^^ But now I have an oder issue. If I send G29, G32 or G33 the hotend goes out of bed and I have to quickly stop it before dammage. My Z_PROBE_X and Y seems good, no? Where is there something who tell it to go so far out of bed…
-
year, I'm stupid... it was the jumpers lol. I've never used this motherboard so... thanks!
-
Hi, I'm using the 1.0.5 version, I think it's the last one. I don't understand " G33 does not work because you have not compiled distortion correction support ". What do you mean? Sorry for this "stupid" question
-
Thank you very much ! But when I Connect my printer, I send a homing and a G33 or G33 S2, I’ve got that in the logs 15:42:50.878 : N18 G28 *10 15:42:50.881 : Info:Autoleveling disabled 15:42:51.487 : SelectExtruder:0 15:42:51.496 : X:0.00 Y:…