Bender2k
About
- Username
- Bender2k
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Yes! I did no print until now, but 244Hz makes PWM usable with my pump !The pump starts with S50 and i have good flow between S100 to S255. Maybe 500 would be even better, but also with 244 the "pulsing" is gone, so i can use it. THANK YOU !
-
Okay, but what is the problem to increase the fan frequency to, let me say, 256Hz with much less resolution? The resolution should not be a problem for fans or DC motor pumps, is it? I also had problems with LED flickering when my hotend was running…
-
I dont think i need khz, because the motor is big and has some inertia.The pump itself is small and produces 0,5bar. Not so much to fight against. 200-500Hz would be nice...Why is that not possible?The Hotend Heater PWM can provide 122Hz. It's just …
-
Hey guys, today i connected a Air Pressure Pump to the Ramps Board for Cooling. Like this one:http://www.pollin.de/shop/dt/ODI5OTY2OTk-/Bauelemente_Bauteile/Pumpen/Luftpumpen/Luftpumpe_DAYPOWER_LP36_12_12_V_.html But after turning it on, i was shoc…
-
Downloaded everything (Firmware incl. config)I also deleted the old download every time.
-
I created a new firmware 5 times now and the bug was still present. Now i changed all values (T0, T1...) to wrong ones, created a firmware, changed it back to the correct ones, created a firmware again and it is wirking now! Temperatures are now cor…
-
Thank you! Regarding issue 1: Is the lates version already released? I created the firmware today 0.92.8 and i still have the problem?Regarding issue 2: So the Jerk Speed is always the minimum speed for all travels? Sorry i didn't get it. Regarding …