› ›

shero2010

About

Username
shero2010
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Greetings, Thank you for your answer! I found the solution. The homing system works so when the "wagon" touches a button, it knows its position is 0. The thing is, the printer set the position Z on 0 when the button is pushed. Slic3r set the posi…
    in Z goes too up after homing Comment by shero2010 September 2023
  • ps : I looked everywhere I could, I don't see the same issue I have anywere. Or my keywords are wrong/bad, also a high probability..
    in Z goes too up after homing Comment by shero2010 September 2023