› ›

Dksre

About

Username
Dksre
Joined
Visits
47
Last Active
Roles
Member

Comments

  • Thank you for the response. Is there a way to set the display to relative coordinates? I have some prints where i am changing filament color at a certain Z height (in the gcode) and i usually keep an eye on z height (previously marlin) so i know if…
    in G92 Set position not shown on printer display Comment by Dksre June 2016
  • Is it possible to use a combination of the two?
    in Linear vs quadratic advanced pressure control Comment by Dksre February 2016
  • Many thanks
    in Print quality test generator Comment by Dksre January 2016
  • That worked! @repetier thank you for your time helping. Is there a way to add that sort of a "hack" to a G28 (Zxytz) I had a look at the code to try this but I am uncertain where would be an appropriate location to insert it. I am asking this b…
    in BLTouch Comment by Dksre January 2016
  • I have used one of these sensors in MarlinFirmware and it worked well. The only odd thing about the sensor is that to drop the pin down below the nozzle it is a servo movement (setting servo to 10 deg from memory. And 90 to raise it) BUT every si…
    in BLTouch Comment by Dksre January 2016