› ›

steve4545

About

Username
steve4545
Joined
Visits
20
Last Active
Roles
Member

Comments

  • Hey, just a quick update. Took me a while to get back to it but the second #define option worked a treat. The z axis turned out to be a fault in the brass nut and printed bracket, with the bracket not flat on top causing the nut to load up one side.…
    in Z Axis stutter on up, X axis homing issue Comment by steve4545 February 2016
  • Okay, thanks. I will have a look at the rods and nuts first, then play with different/separate drivers. I get the impression it's an electronic fault or overload of some sort mainly as it does still raise/lower smoothly after about 50mm height. I co…
    in Z Axis stutter on up, X axis homing issue Comment by steve4545 February 2016
  • I have reinstalled Arduino and updated libraries. Filled in the firmware 92.8 and saved. Ran through IDE no problems, no errors. To anyone else reading: I have also thrown the Melzi board into the (Rubbish!) BIN, added a 400W PSU (12V @ 33A) and f…
    in SDSS error when verifying Firmware Comment by steve4545 January 2016
  • Cool thanks. I'll uninstall it completely and start from scratch with the new version. Thanks again.
    in SDSS error when verifying Firmware Comment by steve4545 January 2016
  • Okay, it cleared that error and gave me another: Arduino: 1.6.7 (Windows 10), Board: "Arduino/Genuino Uno" sketch\libraries\twi.c:1:17: fatal error: twi.c: No such file or directory  #include                  ^ compilation terminated. exit st…
    in SDSS error when verifying Firmware Comment by steve4545 January 2016