WestonWW

Comments

• I'm having this same issue. Any chance your could compile a Pi image of 0.80.1 that I can test? If it's time prohibitive I'll build up my Pi with the package above later this week. Thanks!

  in 0.80 not running start and end scripts Comment by WestonWW November 2016
• Print worked well, I can get a tighter tolerance on the nozzle height because I'm not fighting a moving bed anymore :-) I checked the motor and stepper temps and they stayed normal.  I guess if you were going to change the coding there could be a ti…

  in Hardware 3 point bed leveling - steppers B & C disabling after G32 alow bed to fall out of level Comment by WestonWW June 2016
• Spoke too soon, I rebooted the board and Pi server and it leveled correctly and all the Z motors stayed active after. Now to try a print, I'll report back an other issues. 

  in Hardware 3 point bed leveling - steppers B & C disabling after G32 alow bed to fall out of level Comment by WestonWW June 2016
• If I comment out the following lines:    //motor2->disable();    //motor3->disable(); // now bed is eventhe G32 sequence Fails:fatal:G32 leveling failed! Printer stopped and heaters disabled due to this error. Fix error and restart with M999 M…

  in Hardware 3 point bed leveling - steppers B & C disabling after G32 alow bed to fall out of level Comment by WestonWW June 2016