wholloway
About
- Username
- wholloway
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
I set the 0,0 position in the center of the bed. Printer now homes the head in the center. Everything working fine now. Thanks for the help.
-
I set the baud rate in the firmware to 115200, then uploaded to the printer. Connect with new baud rate and everything works. Thanks for the help.
-
Same problem here. I can center the part on the table using Repetier, when I slice it, it moves back to 0,0 (home) position. I tried modifing some of the settings, nothing has worked yet.
-
I had to lower my baud rate to 9600, I was then able to connect. Same problem though, I cannot move the heads or receive any data. The commands get hung up in the buffers.