YuviiSalhan
About
- Username
- YuviiSalhan
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Repetier said: No it can't and it would also not help in general since fan commands must be synced with movements and printer path planning. Repetier-Firmware has a laser mode which does this conversion printer side so it can sync with moveme…
-
Can the repitier host be set to (G Code) turn Off the fan to turn on the laser during extruding and turn on the fan to turn off the laser during non printing/extruding movements?