labalast

Comments

• I did not ask you to setup endstops there. If you think that Repetier firmware is better than Marlin, you could just say so. There is no need to be rude. I am quite sure that Marlin is setup ok, and that Repetier is not reconizing that. If you have …

  in M119 comand does not report change in stopswitches status Comment by labalast January 2016
• The problem is Repetier sees the endstops triggered even when all is opened. Why it doesn't change status when stopswitches are triggered or not? 

  in M119 comand does not report change in stopswitches status Comment by labalast January 2016