› ›

FDMBot

About

Username
FDMBot
Joined
Visits
39
Last Active
Roles
Member

Comments

  • Correct - CuraEngine. I found the slider. Didn't realise it is responsible for infill. Thank you again.
    in Cura doesn't use settings Comment by FDMBot January 2016
  • Now i found another problem. Cura does not apply Infill settings. Always print ~5-10%. And there is no Honeycomb option.
    in Cura doesn't use settings Comment by FDMBot January 2016
  • I'm end up with this code ; Default start code M220 S40 ; 40mm print speed G28 ; Home extruder G1 Z15 F{Z_TRAVEL_SPEED} M107 ; Turn off fan G90 ; Absolute positioning M82 ; Extruder in absolute mode M190 S110 ; Bed Temp ; Activate all used extruder…
    in Cura doesn't use settings Comment by FDMBot December 2015
  • ; Default start code G28 ; Home extruder G1 Z15 F{Z_TRAVEL_SPEED} M107 ; Turn off fan G90 ; Absolute positioning M82 ; Extruder in absolute mode {IF_BED}M190 S{BED} ; Activate all used extruder {IF_EXT0}M104 T0 S{TEMP0} G92 E0 ; Reset extruder posit…
    in Cura doesn't use settings Comment by FDMBot December 2015
  • Same problem with the temperatures but on Windows 7 Pro 64. Setting 110 degrees for the bed and 225 degrees for extruder. But when i hit print button it always drops temperatures to 50 for bed and 210 for extruder. I have to pause the printing, rise…
    in Cura doesn't use settings Comment by FDMBot December 2015