› ›

Blisk

About

Username
Blisk
Joined
Visits
12
Last Active
Roles
Member

Comments

  • Thank you for answer I already tried that. But now I have switched to slicer, works better faster and holes are almost right dimensions.
    in Printed holes much smaller Comment by Blisk July 2016
  • I think there should be settings in slicer to put value for compensation of holes.
    in Printed holes much smaller Comment by Blisk July 2016
  • I have 0.1 mm layer and slow moving but still. Thanks for advice.
    in Printed holes much smaller Comment by Blisk July 2016
  • Ok I have enabled log but it is not created in folder where it should be so I copied log at bottom of windows. Baud rate is setted as it should be. CPU is not even at 35%. I will test also server Here is a log 10:02:08.174 : Error:No Line Number wi…
    in Printer breaks alot Comment by Blisk June 2016
  • I also tried that, power off printer and unplug it from USB, it was the same. I tried today to print some object from Interent and it prints ok, with no problem. So it must be something wrong with software I maded my 3D object and exporting iz to .s…
    in crashes during printing 1.6.0 Comment by Blisk December 2015
  • In Virtual printer it prints ok with no problems. But when I print on real printer, repetier goes white with no message else just repetier crashed.
    in crashes during printing 1.6.0 Comment by Blisk December 2015
  • It is activated in printer settings. I have put coordinates to go on home position but Z axis on top. Always printing on host But point is it never move from printing object it stays on top of it. It worked in 0.95 but not in 1.6.0
    in Park position Comment by Blisk December 2015