robertalpha
About
- Username
- robertalpha
- Joined
- Visits
- 9
- Last Active
- Roles
- Member
Comments
-
Ok, I have found that the feed rates for extruder 2 are way to small, and started a new discussion in the slic3r category Thank you so far
-
I do have selected extruder 2 for support material, and the printer makes the correct movements for the second extruder, including the offset, but it don't extrude any material. In g-code, the commands for selecting the two extruders (T0 and T1) are…
-
Please, that would be very helpful!