nickcook

Comments

• I meant to say I don't understand if it's connected why it doesn't become active. I know when the firmware was loading it didn't have my Melzi board to select so I just accepted the one on offer

  in Cannot get M501 to read the EPROMs Comment by nickcook December 2015
• it comes up with M105 *0 then M105 *6 etc but still the firmware EEPROM configure stays gray I don't understand if it connects

  in Cannot get M501 to read the EPROMs Comment by nickcook December 2015
• Yes I'm connected direct. So running 64bit Windows should make no difference? Can you suggest a direct link so I make sure I'm using the right version of firmware and driver. Many thanks in advance

  in Cannot get M501 to read the EPROMs Comment by nickcook December 2015
• Thanks for trying to help. Firmware configure is gray so cannot be selected. I have tried reloading the firmware but still no good. I have windows7 64 bit do us this make a difference? Thanks

  in Cannot get M501 to read the EPROMs Comment by nickcook December 2015
• I have uploaded repetier firmware and I still can't set the eeprom function. I can run the printer from repetier so it mets be connected ok. Do I have to set any jumpers to do it? I have a Melzi 1.1 board

  in EEPROM read/write Comment by nickcook December 2015
• How do I select repetier firmware please. I have tried quite a few now to have a play with the settings and seem to be getting in a right pickle

  in eeprom configuration greyed out Comment by nickcook December 2015
• Sorry but how do I do that. I can't see EPROMs setting tab. How do I know if I have complied the firmware. Cheers

  in Cannot get M501 to read the EPROMs Comment by nickcook December 2015