› ›

mikkk

About

Username
mikkk
Joined
Visits
5
Last Active
Roles
Member

Comments

  • Ok I see. If you actually put some Offset in the Firmware tool and you upload it to your printer it will automatically convert the offset in "mm" to "steps" with the X/Y steps per mm as factor. For example you have 160 steps per mm X/Y and you set …
    in Extruder Offset measured in wrong unit Comment by mikkk November 2015
  • Same problem with 0.92.6! You set the wait retract distance in "mm". But when you upload the firmware to your printer the EEPROM shows the "mm-Value" multiplied by the Extruder steps / mm you set earlier. For example: I set the "Wait retract dis…
    in Wait retract distance- 0.92.5 Comment by mikkk November 2015