gwc2795
About
- Username
- gwc2795
- Joined
- Visits
- 48
- Last Active
- Roles
- Member
Comments
-
Thank you
-
Thanks for the help. G29 works, the bed is probed in 4 locations. But I do not see the z axis compensating as the nozzle is moving over the bed during printing. I read about G32 so I tried it. The results was less than acceptable. The initial z prob…
-
@gwc2795: The PiBot Display controller may work with the display but for sure not with the buttons, as you can see on the PiBot schematics: http://reprap.org/mediawiki/images/d/d6/PiBotExpandBoardV1.4-1.pdf every button is on a separate pin, but on …
-
I changed #define ENDSTOP_Y_BACK_ON_HOME 1 to #define ENDSTOP_Y_BACK_ON_HOME 10it works perfectly.The bed slides forward under the inductive sensor and I have consistent height and objects print well.Thanks
-
I am trying to comprehend your advice. The original firmware sent with the P802M does compile. I need to make changes for auto bed leveling. Can I use the V0.91 configuration tool and only download the config.h file? If I download the entire V0.91 p…
-
I purchased this 3D printerhttp://www.aliexpress.com/item/The-seventh-Generation-Prusa-i3-3d-Printer-DIY-kit-transparent-color-P802M-High-Precision-Reprap-Big/32340184418.html It has the screen you show with the 5 buttons, Repetier firmware and a Me…
-
Cirrently #define ENDSTOP_Y_BACK_MOVE 5 Dhould I set it to #define ENDSTOP_Y_BACK_MOVE 15 to move the toward the extruder by an additional 10mm?
-
Thank you
-
I have never selected a pin. I have only selected from the drop down menus in V0.91. The first set of errors was produced because I do not have a case light so I selected "Case Light Pin" "disabled"The second set of errors occurred because I selecte…
-
Thanks for the reply. I changed it to fan_pin and that error disappeared but was replaced by This report would have more information with "Show verbose output during compilation" enabled in File > Preferences.Arduino: 1.0.6 (Windows 7), Board:…
-
Error codesThis report would have more information with "Show verbose output during compilation" enabled in File > Preferences.Arduino: 1.0.6 (Windows 7), Board: "Sanguino W/ ATmega1284p 16mhz"Printer.cpp: In static member function 'static vo…
-
I am completely new to Repetier firmware. V0.92 will not compile for me but I think I am using the wrong version of Arduino IDE. The printer has a Melzi control board and I have not been able to get the sanguino board to show up with later versions …
-
I rebooted the computer and opera now shows a download button for V0.91.Thank You
-
I was running opera and the button did not show up althoght V0.92 does. I tried Chrome and the v0.91 download button shows up. I am completely new to Repetier firmware. V0.92 will not compile for me but I think I am using the wrong version of Arduin…
-
Repetier-Firmware configuration tool for version 0.91 Rev 8 still will not allow me to save the file. V0.92 does.
-
Thanks for taking care of that. I was thinking I would have to go to another firmware.
-
I should have added thet I am on Win7 Pro, I have tried with IE, Mozilla (Firefox), Chrome and Opera. I get the same results on each of the browsers. I have cleared cache, history, rebooted the computer and still get the same results. Any help would…