OGStyle
About
- Username
- OGStyle
- Joined
- Visits
- 51
- Last Active
- Roles
- Member
Comments
-
No I didn't
-
I redone the calibration and it was fine. I will try doing 200%. I do the first layer on .3 the drop it down to .2 or .1.
-
-
My raft layer doesn't look to good either. http://s24.postimg.org/9wk1iqx79/Raft.jpg
-
I got it working there was something wrong with the software on the printer or on the Raspberry Pi. Now it working great. Thanks for the help. I will keep the oven thing in mind.
-
I tried all my filaments and they did the same thing. I keep my filaments in a Ziploc bag with the moisture packets. The plastic comes out of the nozzle fine when I load a new filament. All I have is abs. Thanks
-
The filament is sputtering. Why would it be doing this?
-
Thanks. I'm new to the repetier firmware and slicer. I'm still learning.
-
Is there a way to make the printer slow down when it gets to that part?
-
Ok. Thanks
-
I did the manual calibration with a piece of paper. I'll have to try setting an amount. Thanks
-
Thanks. I think that I will leave it alone. I have a few more questions that you might be able to help me with. When I print something I have the skirt enabled but it usually doesn't print it right and it messes up the bottom of my print. It is…
-
Solved