› ›

Bishop

About

Username
Bishop
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Okay...so I finally got this figured out. Even though my printer was working with version 0.91, I went ahead and swapped out the power supply to rule this out as the cause.  New power supply did not have any effect, so I started looking more into t…
    in Weird Stepper Motor Behavior Comment by Bishop November 2015
  • PDM for both heaters were disabled, so just out of curiosity I tried it with them enabled.  After about 1 minute, the RAMBo just shuts down.  I replaced the Power Supply to rule it out as a possibility; same behavior as before.  After swapping out…
    in Weird Stepper Motor Behavior Comment by Bishop November 2015