› ›

Elias6

About

Username
Elias6
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Hab jetzt einfach den PID Drive Max auf 64 gestellt... der Drucker heizt sich jetzt sehr langsam auf aber bleibt perfekt auf 200 Grad stehen. Dankeschön!
    in Configuration.h location? Comment by Elias6 May 2023
  • Ich verstehe die EEPROM Einstellungen langsam... Habe die Werte auf 128 gestellt, jetzt heizt es wesentlich langsamer. Perfekt, ich spiele mit diesen Werten noch ein bisschen rum und dann müsste es passen Dankeschön!
    in Configuration.h location? Comment by Elias6 May 2023
  • Can I speak in German with you? Ich merke gerade, dass ihr Unternehmen aus Deutschland kommt... 
    in Configuration.h location? Comment by Elias6 May 2023
  • I tried this command: M303 E0 S140 C8 and it said "Error: PID Autotune failed! Temperature too high" the temperature then rised quite slowly to 198 degrees and is going back now.
    in Configuration.h location? Comment by Elias6 May 2023
  • I'm using the version 2.1.6. I entered this command: M303 E0 S200 C8 What command should I try exactly? Thank you very much for your fast replies btw
    in Configuration.h location? Comment by Elias6 May 2023
  • The board is giving out 12V and my extruder also is meant to be used at 12V, but the old one had 20 Watts/ 6 Ohm instead of 40W/3Ohm.
    in Configuration.h location? Comment by Elias6 May 2023
  • Sorry, I'm new to the entire topic. I have a new 40 Watts Extruder and if I'm doing the M303 command (PID tuning) the temperature is rising extremely quick to 280 degrees, not 200 how it should. What exactly do I have to change where to let it rise …
    in Configuration.h location? Comment by Elias6 May 2023
  • Ok thank you for the answer. My Problem is that in the FT Software as well as in yours i dont get how to do the PID tuning. I switched to an hotend with more watts and i dont know where to change the bang _Max etc...
    in Configuration.h location? Comment by Elias6 May 2023