AASC

Comments

• Checked again, only command being sent is 22:38:22.407 : N136 T1 *31 I agree it doesn't make sense so checked again and got the same signature. Even tried reversing the t/c and heater wiring on my system and it is still the reported extruder 2 th…

  in Dualhead temperature control - offset until switching heads for first time Comment by AASC October 2014
• ... probably wasn't clear, in bullet 3 (after switching extruders in RH), both extruders show as 225C on the bar graphs, E1 is at 225/230 and E2 is now at 235/240C

  in Dualhead temperature control - offset until switching heads for first time Comment by AASC October 2014
• Found it but I'll leave the post - it is the little pencil (?) icon on the top bar. Andrew

  in 1.05 - how to enable log view ? Comment by AASC October 2014