shogun
About
- Username
- shogun
- Joined
- Visits
- 120
- Last Active
- Roles
- Member
Comments
-
extr 1 steps per mm my setting for a prusa i3 is 120 But search for a youtube vid that desciebs how to calibrate the extruder soon i will have a awesome extruder calibration vid
-
#define MIN_HARDWARE_ENDSTOP_Z false -> true #define ENDSTOP_Z_MAX_INVERTING true ----> false
-
#define MAX_FEEDRATE_X 400 #define MAX_FEEDRATE_Y 400 #define MAX_FEEDRATE_Z 4 #define HOMING_FEEDRATE_X 100 #define HOMING_FEEDRATE_Y 100 #define HOMING_FEEDRATE_Z 2 I think your z feedrate is to low
-
Why dont you loas your old config file into the online repetier configurator
-
Try using a short cable an regenerate the g code, had the same problems ordered a card reader for ramps
-
SOlved Cache size raised from 63 to 127 and right now using a 20cm insulated usb cable no buffer errors
-
Open repetier Than hit config-> eeprom configuration Zaxis stepps per mm If you have a prusa it schould be 4000
-
Try this LINK
-
IF you looke better you will se that he made the changes that i told him to make
-
Change #define ENDSTOP_Y_MAX_INVERTING true #define MAX_HARDWARE_ENDSTOP_Y true to #define ENDSTOP_Y_MAX_INVERTING false #define MAX_HARDWARE_ENDSTOP_Y false AND #define INVERT_Y_DIR 1 to #define INVERT_Y_DIR 0
-
Thank you i will buy new cables and try it out and what could be the problem when in the middle of the print this errors comes out Communication timeout - reset send buffer block
-
Its a broken motor iv tested it with a spare 42HBC110-25 but the 42HBC110-25 has 6wires now i need to figure out how to use it till a new nema17 arrives thanks
-
HI thank you you had right the driver was burned. Now im geting a klicking nois from the extruder motor, and the shaft vibrates, but does not spinn. thanks
-
Motor works when i connect it to a other axis. Driver orientation is correct