mhackney
About
- Username
- mhackney
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
@Repetier - working great, thanks!
-
Perfect, thanks!
-
@Repetier - does the ENDSTOP_Z_BACK_ON_HOME parameter actually adjust the Z = 0 or just back off the "switch" (in my case the bed)?
-
Ok, thank you for the reply! I do probe with a hot bed and hot extruder, retract and clean the ooze so no filament is interfering with the results. The bed on this machine is not terribly rigid, there is indeed a little flex during a probe. I was no…
-
Repetier, I've read your posts re auto-leveling and probing a Cartesian printer. But you add the caveat "That is why I prefer z max homing and why it is the only real solution wit z probing (with some very special exceptions)." Here's my setup: a Ta…
-
Thanks for the reply. I might add z max homing then.