Belgath

Comments

• Is there any plans in English?

  in Jam / Out of filament Sensor Comment by Belgath January 2016
• Is there a good document on using FSRs for auto leveling a delta,

  in New to Repetier setting up RADDS+DUE+RAPS128 Comment by Belgath January 2016
• Thanks for the help Couture.

  in New to Repetier setting up RADDS+DUE+RAPS128 Comment by Belgath January 2016
• Have it up and running had a bad thermistor and my Hall-E where normally closed. I had thought they where normally open. Now I. Jest need to set up auto leveling.

  in New to Repetier setting up RADDS+DUE+RAPS128 Comment by Belgath January 2016
• Thanks for the feedback.

  in New to Repetier setting up RADDS+DUE+RAPS128 Comment by Belgath January 2016
• https://drive.google.com/open?id=0B3iJWeGZCywBSnEwcE5CZTJVU3Msame broblem as above, jest inverted my x y z 

  in New to Repetier setting up RADDS+DUE+RAPS128 Comment by Belgath January 2016
• I jest inverted XYZ  same problem as above here my Configuration file.

  in New to Repetier setting up RADDS+DUE+RAPS128 Comment by Belgath January 2016
• It states that Due boards need a Delay stepper high signal. How do i calculate this?

  in New to Repetier setting up RADDS+DUE+RAPS128 Comment by Belgath January 2016
• Got it up and moving sorta x and y moves are working z is moving up 10mm when I try to move it down and does nothing when I try to move it up. It sees the end stops, thermistors. But the heat bed and extruder are not heating up so back to look at my…

  in New to Repetier setting up RADDS+DUE+RAPS128 Comment by Belgath January 2016