diverkev
About
- Username
- diverkev
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
The object was quite small (3cm cubed).It slows down after slicing, when the printing starts to the point where it comes to a complete stop. The graphics are set to the low level setting and I do not have the screen on which shows the print progress…
-
So can you explain the problem that I mentioned in my original post and how I can get around it?
-
I do not know what the difference is between a host and firmware. When I open repetier from the shortcut on my desktop Repetier 0.84 is displayed in the top left corner of my screen.