› ›

9990

About

Username
9990
Joined
Visits
1
Last Active
Roles
Member

Comments

  • A couple of things. The server and host versions are at the very beginning of this post. I also tried getting repetier host to run on a linux system, but couldn't get it to connect. Unfortunately, in more recent versions of windows, (like the system…
    in Can't change z min pos Comment by 9990 April 2023
  • Now we're getting some where. Sorry I'm just a construction worker trying to fix this for his kid, so I don't understand some of these values. My eeprom only shows the z values I listed above. I had no idea there is "z end stop." This link is simila…
    in Can't change z min pos Comment by 9990 April 2023
  • Closer, but backwards. The new nozzle is not 10mm shorter than the deck, it is 10mm longer. Since the nozzle is too long, it is crashing into the side of the deck. My EEPROM has the following settings-z min pos = -0.99.2  changed to 25 z max lengt…
    in Can't change z min pos Comment by 9990 April 2023
  • That didn't work. I need to clarify this printer's setup since not all printers use the same design. The nozzle for this printer only moves in the x and y dimensions. The deck starts at the top of its z range, then moves down as successive l…
    in Can't change z min pos Comment by 9990 April 2023