› ›

JMK

About

Username
JMK
Joined
Visits
4
Last Active
Roles
Member

Comments

  • Ok, is this right, load my configuration file into the online config tool and change only the motor and when I save everything should be the same but the motors. Will try, Thanks
    in Axis Drift Comment by JMK October 2015
  • When you say switch motors in firmware do you mean changing pin assignments?
    in Axis Drift Comment by JMK October 2015
  • I set the check endstop to false, I will try 0. It is driving towards the endstop. By switching I swapped the X and Y connectors on the board and swapped the limit switch so X became Y and Y became X. The drift went with the new X
    in Axis Drift Comment by JMK October 2015