Flybye
About
- Username
- Flybye
- Joined
- Visits
- 62
- Last Active
- Roles
- Member
Comments
-
Update, I created a filament setting called "no extrude", set the extruder temp to 0 and the bed settings to 65. I assigned it to the LEFT extruder and that worked for the the bed..... Still trying to figure out the fan. Will post back when I do
-
I see no comma used as a decimal value the slic3r_settings.ini. Hopefully it will work in 1.3.0 when it comes out. It's curious that Cura will generate the code for the right extruder only, but when the print starts it shuts off the extruder but …
-
Ok, Just tried it with the prusa version. Same behavior, not heat or fan generated. I also tried it with Cura and it worked. Not really familiar with Cura but will do some reading and testing. I really appreciate your help. Thanks again for all of …
-
Thank you for that. Sorry be away so long, personal issues. Anyway, I decided to try and get my camera to work and lo and behold the printer connected! Dumb but fortunate luck. I wish I could post why so I could help others with the same problem. My…
-
update: Still no joy after direct connection through BBB. The only time I can obtain a com port is with direct connection from my computer to the 3d printer and Repetier Host. Any other suggestions are welcome.
-
Thank you for that. I did try the drop down and there is nothing there. I think when I get home I will connect the BBB directly to my computer and the printer and see if I can get what I need that way. Will let you know. By the way, I am up to date …
-
Thank you for the quick response. I am a newb as you can tell. I had read that the structure that I should use for Linux is " COM3= /dev/ttyS2 or /dev/ttyUSB2 or /dev/ttyACM2" I tried all 3 with no success before my original post. I suspect that it …