› ›

mars0120

About

Username
mars0120
Joined
Visits
10
Last Active
Roles
Member

Comments

  • Yes it is a delta.   My probe triggers when the print nozzle is 5.7 mm above the print bed.  I had the sign wrong on that field.  Below is the more appropriate distortion correction matrix. The nozzle no longer goes crazy but it still rides too high…
    in G33 distortion correction Comment by mars0120 February 2016
  • I would like to suggest adding the correction radius to the EEPROM values which can be edited from Repetier Host software.
    in Calibration/BedLevel Comment by mars0120 January 2016
  • OK so I think I figured it out.  the G33 command doesn't use the EEPROM values X1Y1X2Y2X3Y3.  It uses the value from the configuratin.h for "correction radius"  This is set in the initial setup and is not visible from the Repetier Host configuration…
    in Calibration/BedLevel Comment by mars0120 January 2016
  • By the way if i use M205 to output the EEPROM settings they are changing as I use all of the methods above but when I use G33 the machine continues to move to a set of coordinates out of range.
    in Calibration/BedLevel Comment by mars0120 January 2016
  • Clearly I am not getting this correct.  I have tried editing the coordinates in the Repetier Host Software Configuration dialog box and then using M500 to save them.  I have also gone back through the online Firmware setup wizard and downloaded and …
    in Calibration/BedLevel Comment by mars0120 January 2016
  • This is still not making sense.  I put the number 10 into the box for X1 and 10 into the box for Y1.  These are well within the range of my machine but I still get the error.  If I want X1 to be 10mm what should I be putting into the dialog box? Is …
    in Calibration/BedLevel Comment by mars0120 January 2016
  • I am not sure I understand.  The coordinates I specified are not outside the reachable area.  I put the X1Y1/X2Y2/X3Y3 in the configuration dialog box which is labeled "mm".  Am I supposed to be specifying a position in steps from a home position?
    in Calibration/BedLevel Comment by mars0120 January 2016
  • I am still struggling here.  I have read pages of repetier documentation and I can't figure out the distortion correction.  Some repetier pages say G32, some say G33 and you have suggested G29.  Can you please tell me which is the correct command fo…
    in Calibration/BedLevel Comment by mars0120 January 2016
  • Thanks, I got an answer in the extruder and bed section.
    in Calibration/Bed Leveling Comment by mars0120 November 2015
  • First, thank you for knowing what I am talking about.  I can't find a reference for this anywhere. I have iterated Diagonal Rod Length, Horizontal Rod Radius, Alpha A/B/C many times.  Unless the behavior is non-linear changing any of those from my c…
    in Calibration/BedLevel Comment by mars0120 November 2015