Baelt
About
- Username
- Baelt
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
The idea is to make a gripper that can remove the plate. The plate is then placed on a holder where the plate is turned 180 degrees, when it gets below 35 degrees the print comes loose and lands in a box. In the meantime, put it in the second plate …
-
It's a robotic arm. It needs a start signal to start its program. when it is finished it must give a signal to pi to run the next print. This is how it should run 50 print jobs.
-
This is how i set it up. and it runs really well. I have 5 raspberry pi b+. Where I have connected 3 or 4 printers. And one that runs as a server/hard disk. All g-code is on the hard drive. I drive it all through. Google Chrome. Logged in to the ra…
-
It's great, then it's just a matter of getting a UR3 installed
-
it was only a test so just a small print. Which @XXXX can you use if you want an output of e.g. GPIO27 when it's done printing? Can I find more info about this? As always thanks
-
just to be absolutely sure. so it's not something coming? when you press print G-code. In the pop-up that appears, you can only choose queue print or print. thought it would make sense if you could choose how many items should be printed and then pr…
-
@fabiomaticus but you can only do it in the pro version, right? @Repetier sorry, what is ui? has anyone tested how many can run on a raspberry 3B+ (only send g-code) can I run 6-7 pcs on a pi? thanks for quick response!