3DP0
About
- Username
- 3DP0
- Joined
- Visits
- 103
- Last Active
- Roles
- Member
Comments
-
Hi, have you find the time to solve the continued triggering problem when using a swith as a filament end sensor?
-
HI, i just updated the firmware of my printer to 0.92.7 version ant tested it. So it still makes the same thing as id did before. Here you have the log file from repetier host https://dl.dropboxusercontent.com/u/16734804/log repetier 1.txt https://d…
-
HI again, So... I finally got time to test the sensor. When I enable the pullup resistor, the change fillament comand is trigered right away after the filament runs out. But there is still a problem with the table. It goes down 5 cm (and it is too m…
-
Hi, 1. I had no pullup enabled (I chenge it and check tomorrow) 2. 5 cm is to much (just normal value as it is on filament option in lcd menu is enough) 3 and 4 I will test once again tomorow
-
Hi, after your correction I had no compilation error and I could load the firmware to my printer. I test the option #define JAM_METHOD 2 (sensor closed when filament inside) and it does work but not 100% the way it should. 1. don't strart the change…
-
-
Here is my latest configuration file.
-
Hi, after update to version 0.92.6 and changing #define JAM_METHOD to 2 or 3 i'm still getting the same error. Extruder.cpp: In static member function 'static void Extruder::step()':Extruder.cpp:1030:1: error: a function-definition is not allowed h…
-
Hi,I have modyfied the #define JAM_METHOD to 2 and 3 but i get an error during compiling Extruder.cpp: In static member function 'static void Extruder::step()':Extruder.cpp:1030:1: error: a function-definition is not allowed here before '{' token { …
-
Hi, thank you for your response. I can't wait till you add this option and i finally can try out my filament end sensor.