› ›

bstott

About

Username
bstott
Joined
Visits
6
Last Active
Roles
Member

Comments

  • The configuration tool output is not correct for the delta - v.0.92.9 Some where this broke going from 0.92 to 0.92.9. I think. I had to manually edit to make the Z values the same as the XY on axis stepper motion and also two other areas which lis…
    in Repetier firmware tool confusing Comment by bstott May 2016
  • Thank you very much for your time and detail regarding my suggestion/request. Granted my suggestion would require some assumptions for perpendicularity of towers to bed, angles between towers to bed center and a few others. But, with a nearly correc…
    in Automating Delta Calibration Setup Comment by bstott September 2015