› ›

BuchnerB

About

Username
BuchnerB
Joined
Visits
5
Last Active
Roles
Member

Comments

  • Thanks to all the suggestions. I found the issue. In the Slicer3 configuration tab there is a pull down called GCode Flavor. It lists RepRap and others. The last item is "No Extrusion". It had some how been selected. Works fine now. Bruce
    in Lost Filament Extrusion in Repitier/Slicr3 Comment by BuchnerB August 2015
  • I tried that but no success. The problem is in Slicer. It is not putting extrusion commands in the gcode. All the movement commands are there but no extrusion so Repetier and the printer just go through the motions. I tested it last night by creatin…
    in Lost Filament Extrusion in Repitier/Slicr3 Comment by BuchnerB August 2015