› ›

jmoody0612

About

Username
jmoody0612
Joined
Visits
5
Last Active
Roles
Member

Comments

  • With the Repetier Firmware, Z barely moves in any direction. The voltage is on point. I have entered all the same settings as I was using with Marlin (which moved the motors just fine, but the Repetier firmware hadly moves Z at all.Any idea? My conf…
    in Z axis and retracting Comment by jmoody0612 August 2015
  • I tried using repetier firmware and the Z axis barely moves at all. All the settings seem to be the same as I manually went through and checked them. But Z still doesn't move, ever.
    in Z axis and retracting Comment by jmoody0612 August 2015
  • I updated as best as I could, but Z still lifts ANY time I retract after extruding.Is there a section for this in the firmware other than what is mentioned above?
    in Z axis and retracting Comment by jmoody0612 August 2015
  • So my configuration.h file doesn't include any of this. It is the marlin files that folgertech has supplied with the printer kit. Interesting.
    in Z axis and retracting Comment by jmoody0612 August 2015
  • Thanks for the info. Could you point me to where these are? I checked but couldn't find them.Thanks
    in Z axis and retracting Comment by jmoody0612 August 2015