Brian
About
- Username
- Brian
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Hi George,I used E1 pins instead of E0, just as another attempt to get around the extruder (not functioning) problem.just moved the Extruder stepper cable to E1 from E0 to see if it made a difference.Hi Repetier, I guess I will need to raise this is…
-
Hi Repetier, I am still.... experiencing the same problem. I have upgraded to 0.92 firmware and V1.06 host. Extruder 0 does not respond to manual control in Repetier host. My system uses a Azteeq X3 controller. Panucatt supplied test firmware wor…
-
Hi Repetier, I am experiencing the same problem. Extruder 0 does not respond to manual control in Repetier host. My system uses a Azteeq X3 controller. Panucatt supplied test firmware works, so Extruder motor is wired correctly. Repetier firmware d…